User Guide HC - Copyright © 2008 MAC3. All right reserved.
Disegno 6328
38
Via Baldanzese, 149 50041 Calenzano FI
Tel. 055 8877672 – Fax 8877068
www.mac3.it - e-mail: mac3@mac3.it
7.1. Restore of the factory parameter data set
Using the Maintenance menu it is possible to restore the factory parameter data set. After
restoring you need to repeat the installation procedure.
During usual operation enter the Maintenance Menu keeping pressed for 3 seconds the key
+ .
I twill be displayed
Keeping the key --> the display will show the parameters of Maintenance Menu. Run all
the parameter till it will be displayed:
With key + set the value 1.
Press ENTER and keep pressed till will be displayed ”Done……”.
It will be displayed:
The device will be stopped and restart automatically and all the parameters will be on factory
data set.
Language
ResetFactoryConf
Reset
To Next Page
Loading...
