MACDEV PRIME - Quick Setup; Switching On and Off; Firing Your Marker; Beam Sensor Operation

Cycle mode
Power buon
(for power on/o)
Scroll buon
(for eyes on/o and
programming)
OLED Display
Membrane Pad Installing a preset air system
Your marker comes equipped with a high quality venng ASA (Air System Adaptor)
that is designed for use with commercially available air/nitrogen systems.
The venng ASA included with your marker uses a lever to turn the air from your
preset system on or o. Before installing your preset air system, you must move the
lever into the o posion, which is ipping it towards the front of the marker.
Once this is done, carefully screw your air system into the ASA unl it stops.
Turning the air on and o
To pressurise your marker, swing the lever backwards into place in the ASA body.
This will depress the pin on the end of your air system and pressurise the marker
(provided you have sucient air in your air system).
To depressurise your marker, ip the lever back to the forward posion. You should
hear air being vented from the ASA. Your air system is now turned o and safe to
remove.
WHEN SCREWING YOUR AIR SYSTEM INTO THE ASA, THE THREADS SHOULD BE
LOOSE. IF AT ANY POINT THEY BECOME TIGHT, DO NOT FORCE THE THREADS,
THIS MAY CAUSE DAMAGE TO YOUR AIR SYSTEM OR YOUR MARKER!
8
Installing an air system
Turning the air on
Baery meter
Sensor status
Cycle speed (max)
ROF meter
QUICK SETUP
Switching your Prime on and o
The on/o buon is located on a membrane pad on the rear of the frame. Push the
buon with the power symbol ( ), when done correctly, your OLED will display the
MacDev logo and the marker will be set with the beam sensor system on and ready
to re. Turn your marker o by holding the power buon down unl the OLED system
goes blank.
Firing your marker
If a paintball is loaded in your marker, and the power is switched on, you may re the
marker by pulling the trigger. If a paintball is not loaded, then you need to either load
one, or read the secon below on disabling the beam sensor.
Understanding the beam sensor
Your marker is equipped with a visible light sensor to determine if a paintball is cor-
rectly loaded. This system is used to prevent accidental ball breakage due to misloaded
paintballs. The OLED indicator on the side of your grip will show you the status of the
beam sensor:
Disabling the beam sensor
To disable the sensor (for dry ring), hold the scroll buon on the membrane pad ( )
unl the beam sensor disabled icon appears on the OLED display. You can re-enable the
beam sensor the same way.
Ball loaded Sensor disabled
No ball loaded Sensor fault