MACDEV PRIME - Using Your Prime; Adjusting Velocity; Adjusting the Trigger

USING YOUR Prime
To get the most out of your Prime, make sure that you follow the instrucons in this secon to ensure that the
Prime is adjusted correctly.
Adjusng the velocity
Your Prime is equipped with a single regulator in the frame, to adjust the velocity adjust the regulator seng. Use
an 1/8” allen key from the set provided, and use only small adjustments whilst checking over a chrono. Turn an
clockwise to increase velocty.
Adjusng the trigger
Your trigger has four adjustment screws, they are located in the front face of the trig-
ger and also on the upper face. In order of top to boom, they are the trigger rest
point, spring tension, actuaon point and stop point.
You can easily adjust these screws to personalise the feel of your trigger.
Using a loader with your Prime
Your marker can operate using any commercially available loader. The soware
and beam sensor will compensate for the speed of the hopper, ensuring that
the marker res as quickly as the loader allows.
Installing a loader onto your Prime
Open the cam lever as shown. This should allow your loader neck to t into
the feed tube as shown. If your loader does not t into the feed tube, then
you may have to loosen the cam lever - this is done by rotang the cam lever
(anclockwise). Once your loader is pushed all the way down into the feed
tube, close the cam lever. If your loader is loose, you may need to open the
cam lever, and ghten it (by turning clockwise) to adjust the cam system to
hold your hopper ghtly. Only ever adjust your cam lever by one turn at a me
to prevent overghtening.
Removing your loader
Open the clamp by swinging the lever on its hinge. This will loosen the loader
and allow you to remove it easily. If it does not remove easily, then it means
that you have the cam lever overghtened.
DO NOT OVER TIGHTEN YOUR FEED CLAMP! OVERTIGHTENING MAY
RESULT IN DAMAGE TO YOUR LOADER OR CLAMP.
DO NOT ADJUST YOUR VELOCITY ABOVE 300FPS, AND ALWAYS OBEY LOCAL LAWS
AND REQUIREMENTS.
CAUTION! WHEN ADJUSTING THE SWITCH ACTUATION SCREW, MAKE CERTAIN
THAT YOU DO NOT ADJUST THE SCREW IN TOO FAR, AS THIS MAY RESULT IN
DAMAGE TO YOUR MICROSWITCH.
10
Twist lever clockwise to
ghten the cam lever
system
Adjusng your velocity
Push lever into place to
lock your loader onto
the marker
IOpen the clamp and
push in a loader
Close the clamp to lock
the loader in
Velocity adjustment
Trigger adjustment