MACDEV PRIME - Advanced Setup; Tournament Lock System; Entering Program Mode; Finding and Changing Settings

Replacing the baery
Remove the two screws holding the wrap around grip onto the le hand side of your grip frame. Gently remove the
baery from the clip on harness. Replace the baery with a high quality alkaline 9V baery (type 6LR61).
ADVANCED SETUP
About the tourney lock
The marker board is equipped with a tourney lock system. When the tourney lock system is
acvated, the marker cannot be reprogrammed on the eld - making it tournament legal.
If your board is in locked mode, you can view your sengs, but a lock indicator will be shown
on the right hand side of the screen, indicang that your board will need to be unlocked before
sengs may be changed.
The lock status can be changed by opening the le hand side of the marker wrap around grip
to gain access to the circuit board. The tournament lock is a black buon. Press and hold the
tourney lock buon unl an on screen indicaon of tourney lock status is shown.
Entering program mode
To program the board, hold down the trigger whilst turning the marker on. When done correctly, you will see a message
on your display screen indicang that programming mode is loading. You must connue to hold the trigger unl the
program mode is loaded, then release the trigger.
Finding and changing sengs
Once in program mode, the OLED display will show a current seng. you can advance to the next seng by tapping
the scroll buon ( ). You can go back to the previous seng by tapping the power buon ( ).
Once you have found a seng you would like to change, press and hold the trigger unl the seng changes to
red.
The seng can now be changed by tapping the scroll buon to increase its value (or change to a dierent opon),
or tapping the power buon to decrease its value.
Once you have adjusted the seng to a value you would like, press and hold the trigger again unl the seng
returns to white colour, it has now been saved.
If your tourney lock is on, sengs that can change the tournament legality of your marker will be locked. Their
seng can be viewed, but not changed. You will know if the tournament lock is blocking eding, because a red
lock symbol will show in the upper le hand corner of the screen, and the seng will not change to the usual red
colour. If you would like to change a locked seng, you must open the wrap around grip and hold in the tourney
lock buon. This may be done inside program or normal running mode.
Sengs in detail
Sengs are explained here in detail.
Mode - The type of ring system used, semi auto, Millenium and PSP are common tournament modes. Ramp
mode allows the programming of custom ramping behaviour.
ROF - This is the maximum rate of re allowed by the marker. This seng is only observed if the nex seng, rate
of re cap is set on.
ROF cap - If the cap is enabled, the marker will be limited to the ROF seng. Otherwise, it will re as fast as the
laws of physics (and paint supply) will allow.
Dwell - the amount of me your solenoid is given power - the Prime should be set to a maximum of 12ms. If the
weather is very cold, or your marker requires it, you may set this a lile higher.
12
Tourney lock