MACDEV PRIME - Using the USB Connector

Debounce - the amount of bounce ltering applied by the soware. This seng may be increased to remove un-
wanted trigger bounce.
Ball delay - this is a parameter used to give a paintball me to sele in the breach of the gun. If you have unex-
plained ball breakage, then you may need to increase this seng.
Eye sensivity - the sensivity of the soware to changes in your eyes. Please do not change this parameter unless
directed (default 10).
Forced shot - when enabled, this will allow the user to force a shot by holding the trigger in - even if the eyes can-
not detect a ball. Set this to o, if you would not like to use this funcon.
FSDO me - FSDO stands for First Shot Drop O. If you leave your gun for some me, and the rst shot is lower
than it should be, then you can use this parameter to correct it. This parameter is the me that the soware waits
before correcng for FSDO.
FSDO dwell - this is the amount of extra dwell given to the solenoid to overcome FSDO - if directed to do so by the
above parameter.
Ramp semishots - this seng (and the other three below) is only used if you are using the Ramp remode. This is
the number of semi auto shots which must be red before ramping is allowed.
Ramp rate - this is the number of shots per trigger pull when in ramp mode.
Ramp ROF - this is the rate of re which must be achieved and maintained to stay in ramp mode.
Ramp meout - the amount of me the user can spend below the ramp ROF before ramping is exited.
Sound - turn sounds on or o.
Auto power o - save power by automacally turning the marker o aer 30 minutes.
Load/Save proles - Your marker has two prole save slots. Once you have your marker set up as you like it, go to
save prole and select one of the proles. Hold the trigger in on the prole number you would like, and the cur-
rent sengs will be save to that prole slot. You can reload them at any me using the load prole opon.
There is an opon under load prole, to load factory defaults.
Version informaon and shot counter is shown on the nal seng screen.
Using the USB connector
Your stock board has a mini USB connector on the boom of the board to the right of the 9V baery. The USB
connecvity may be used to update your soware via a standard USB/mini USB cable.
Your marker rmware requires MacDev soware MDFlash V4 or above to update the rware.
Never update your board with soware unless it has been downloaded directly from the MacDev website
(www.macdevpaintball.com), the use of non genuine soware on your stock board will immediately void your
enre marker warranty.
14