MACDEV PRIME - Troubleshooting

20
20
TROUBLESHOOTING
If you are experiencing dicules with your marker, please check this table rst to see if there is an easy soluon
listed. If at any me you are unsure about how to work on your marker, please contact a cered MacDev technician
or service centre.
Symptom Possible Cause Soluon
Although a fresh baery
has been ed, your
marker will not turn on
The baery has not been ed
correctly
Ensure that the baery is rmly connected to
both terminals. Ensure that the posive (+)
terminal is connected to the posive terminal
on your baery.
Your marker leaks from
the solenoid
Leaking bolt #M16-2 o-ring Clean and relubricate the drivetrain with
parcular aenon to the bolt o-ring #M16-
2. Replace if necessary.
Solenoid installaon or operaonal
fault
Check the solenoid is mounted correctly. If
mounng is correct and the seal is in place,
contact your local tech.
Pressure too high Reduce the pressure seng on your inline
regulator
Your Prime uses
excessive air
Keg internal number 19 o-ring leaks Relube and check the keg o-ring. Replace as
necessary.
General leak Make certain that there are no leaks from
your gun or air system wasng your air
supply.
Symptom Possible Cause Soluon
The beam sensor is not
reading correctly
Bolt is not moving Trying to cycle your Prime without air can
lead to sensor fault signals, ignore them un-
less your bolt is moving back and forth.
Eyes are dirty Check that the eyes are clean and not
blocked.
Eyes are faulty Replace the eye pair.
Your Prime is
chopping paintballs
Beam sensor is turned o Always play with the beam sensor
enabled.
Beam sensor is dirty or blocked Clean the breach, bolt and sensor.
Loader is set on a force seng too
high for your paintballs
Some force fed loaders can apply enough
force to break a fragile paintball. If this is the
case, consult your loader manual to reduce
the force seng.
Detents are missing or incorrectly
installed
Replace or re-install your detents.
Eye delay too low Increase the eye delay (pg 13)
Your Prime will not re The trigger is set up incorrectly Ensure that the trigger actuates the micro-
switch by adjusng the actuator screw.
The beam sensor is on, and there are
no paintballs loaded
Load some paintballs.
The solenoid is not plugged in Plug the solenoid into the board.