What to do if both wheels will not pull in forward or in reverse on MacDon Farm Equipment?
If both wheels on your MacDon Farm Equipment will not pull in forward or reverse, repair or tighten loose hardware on pump controls. Also, check the charge pressure if the brakes are binding or not releasing fully, and check the oil reservoir level if there is low oil level and low charge pressure.
What to do if wiring is shorted or the circuit breaker is open in MacDon Tractor?
If the wiring in your MacDon Tractor is shorted or the circuit breaker is open, check the wiring for continuity and manually reset the breaker.
What to do if there is no fuel to the engine of my MacDon Tractor?
If there is no fuel reaching the engine of your MacDon Tractor, you should first fill the fuel tank if it's empty. If the tank is full, consider replacing a clogged fuel filter. Finally, inspect the fuel lines for any blockages or damage.
What causes the wheels to lack pulling ability on a grade with MacDon Farm Equipment?
If the wheels lack the necessary ability to pull on a grade or when pulling out of a ditch with your MacDon Farm Equipment, check the controls if they are loose or worn. Check the charge pressure if the brakes are binding or not releasing fully. Replace the relief valve if the relief valve in the tandem pump is dirty or damaged.
Why are the air louvers emitting an odor in my MacDon M1170 Farm Equipment?
If the air louvers in your MacDon Farm Equipment are emitting an odor, blow out the drainage hose with compressed air if it is plugged. Also, clean the filters if they are dirty.
Why is the heater not heating in my MacDon Farm Equipment?
If the heater is not heating in your MacDon Farm Equipment, open the heater shut-off valve at the engine if it is closed. Replace the thermostat if it is defective. Replace the control if the heater temperature control is defective. Install a thermostat if there is no thermostat in the engine water outlet manifold.
How to stop excessive noise from the MacDon Farm Equipment drive system?
To address excessive noise from the drive system of your MacDon Farm Equipment, first, remove any mechanical interference in the steering or ground speed linkage. Check the charge pressure if the brakes are binding or not releasing fully. Inspect the lines for leakage if there is air in the system. Tighten the hydraulic line clamps if they are loose, and replace worn ball joints.
What causes low oil pressure in MacDon Farm Equipment?
If your MacDon Farm Equipment has low oil pressure, first add oil if the oil level is low. If the oil level is adequate, drain and fill the crankcase with the proper oil.
What to do when the hydraulic oil low-temperature alarm activates on MacDon M1170 Farm Equipment?
If the hydraulic oil low-temperature alarm activates on your MacDon Farm Equipment, run the engine until the hydraulic oil warms up if the hydraulic oil is too cold.
What to do if the operator’s station is not locked on a MacDon Tractor?
If the operator’s station is not locked on your MacDon Tractor, adjust the position of the operator’s station and ensure the lock is engaged.
General| Brand | MacDon |
|---|---|
| Model | M1170 |
| Category | Farm Equipment |
| Language | English |
To Next Page
