MacDon M205 - Maintenance and Servicing

MAINTENANCE AND SERVICING
169552_Supplement Revision D Page 3 of 8
7.4.2 Break-In Inspections
ITEM SEE SECTION
1 Hour
Check Drive Wheel Nut Torque - 170 ft·lbf (230 N·m).
Repeat Checks Every Hour Until Torque Stabilizes.
7.12.1.2
At
5 Hours
Check A/C Belt Tension. 7.8.10.1
Check Caster Wheel Nut Torque - 120 ft·lbf (163 N·m). 7.12.2.3
Check Caster Wheel Anti-Shimmy Dampener Bolt Torque.
Inboard Bolts - 100 ft·lbf (135 N·m).
Outboard Bolts - 85 ft·lbf (115 N·m).
7.12.2.6
Check Walking Beam Width Adjustment Bolts Torque - 330 ft·lbf (448 N·m). 6.3.6
At
10 Hours
Check Walking Beam Width Adjustment Bolts Torque - 330 ft·lbf (448 N·m). 6.3.6
Check NEUTRAL Adjustment. See Dealer.
At
50 Hours
Check Hose Clamps - Air Intake / Radiator / Heater / Hydraulic.
Hand-tighten unless otherwise noted.
Various
Check Walking Beam Width Adjustment Bolts Torque - 330 ft·lbf (448 N·m). 6.3.6
Check Caster Wheel Anti-Shimmy Dampener Bolt Torque.
Inboard Bolts - 100 ft·lbf (135 N·m).
Outboard Bolts - 85 ft·lbf (115 N·m).
7.12.2.6
Change Drive Wheel Lubricant. 7.12.1.3
Change Hydraulic Oil Filters. 7.11.3
Use this table instead of the one provided
on page 122 in the original manual.
Replaces Page 122 in M105 Op Manual
122