What to do if there is cut grain falling ahead of the cutterbar because of reel position on MacDon New Holland FlexDraper FD2?
If cut grain is falling ahead of the cutterbar because the reel is too far forward, move the reel back on arms.
What to do if MacDon Farm Equipment feed draper will not move because of drapers?
If the feed draper will not move and the drapers are loose, tighten the drapers.
What to do if there is cut grain falling ahead of the cutterbar because of ground speed on MacDon New Holland FlexDraper FD2?
If cut grain is falling ahead of the cutterbar because the ground speed is too slow, increase the ground speed.
What to do if side drapers stalling because of material feeding on MacDon Farm Equipment?
If side drapers are stalling, lower the reel or install short knife guards.
What to do if crop not being cut at ends because of header level on MacDon New Holland FlexDraper FD2 Farm Equipment?
If crop is not being cut at the ends, level the header.
What to do if crop not being cut at ends because of reel position on MacDon New Holland FlexDraper FD2 Farm Equipment?
If crop is not being cut at the ends because reel fingers aren't lifting crop properly ahead of knife, adjust reel position and/or finger pitch.
What to do if plastic fingers bent forward at tip on MacDon Farm Equipment?
If plastic fingers are bent forward at the tip, raise the header, decrease the header tilt, or move the reel aft.
What to do if there is crop loss at cutterbar because of cutterbar height on MacDon New Holland FlexDraper FD2?
If you're experiencing crop loss at the cutterbar and suspect it's because the cutterbar is too high, lower the cutterbar.
What to do if there is crop loss at cutterbar because of ground speed on MacDon New Holland FlexDraper FD2 Farm Equipment?
If you're experiencing crop loss at the cutterbar because the ground speed is too fast for the reel speed, increase the reel speed or reduce the ground speed.
What to do if my MacDon New Holland FlexDraper FD2 has strips of uncut material because guards plugged with debris?
If you are experiencing strips of uncut material, try installing short knife guards to prevent guards from plugging with debris.
General| Brand | MacDon |
|---|---|
| Model | New Holland FlexDraper FD2 Series |
| Category | Farm Equipment |
| Language | English |
To Next Page
