To Next Page
T
Tanner BurkeSep 7, 2025
What to do if MacDon Farm Equipment feed draper will not move because of drapers?
- MMelissa BryanSep 7, 2025
If the feed draper will not move and the drapers are loose, tighten the drapers.
What to do if MacDon Farm Equipment feed draper will not move because of drapers?
If the feed draper will not move and the drapers are loose, tighten the drapers.
What to do if my MacDon Farm Equipment has strips of uncut material?
If you notice strips of uncut material, it could be due to broken knife sections. Replace the broken sections to resolve this issue.
What to do if my MacDon New Holland FlexDraper FD2 has strips of uncut material because guards plugged with debris?
If you are experiencing strips of uncut material, try installing short knife guards to prevent guards from plugging with debris.
What to do if there is insufficient side draper speed on MacDon New Holland FlexDraper FD2?
If there is insufficient side draper speed, increase the speed control setting.
What to do if MacDon Farm Equipment feed draper will not move because of relief setting?
If the feed draper will not move because of an incorrect relief setting at the flow control valve, adjust the relief setting.
What to do if crop not being cut at ends because of reel position on MacDon New Holland FlexDraper FD2 Farm Equipment?
If crop is not being cut at the ends because reel fingers aren't lifting crop properly ahead of knife, adjust reel position and/or finger pitch.
What to do if reel not releasing material in normal standing crop because of reel speed on MacDon Farm Equipment?
If the reel is not releasing material in normal standing crop, reduce the reel speed.
What to do if reel not releasing material in normal standing crop because of reel height on MacDon New Holland FlexDraper FD2 Farm Equipment?
If the reel is not releasing material in normal standing crop because the reel is too low, raise the reel.
What to do if MacDon New Holland FlexDraper FD2 feed draper will not move because of bar?
If the feed draper will not move because a slat or connector bar is jammed by the frame or material, loosen the draper and clear the obstruction.
What to do if there is cut grain falling ahead of the cutterbar because of ground speed on MacDon New Holland FlexDraper FD2?
If cut grain is falling ahead of the cutterbar because the ground speed is too slow, increase the ground speed.
General| Brand | MacDon |
|---|---|
| Model | New Holland FlexDraper FD2 Series |
| Category | Farm Equipment |
| Language | English |
