What to do if there is cut grain falling ahead of the cutterbar because of reel speed on MacDon New Holland FlexDraper FD2?
If cut grain is falling ahead of the cutterbar because the reel speed is too slow, increase the reel speed.
What to do if my MacDon Farm Equipment has strips of uncut material?
If you notice strips of uncut material, it could be due to broken knife sections. Replace the broken sections to resolve this issue.
What to do if my MacDon New Holland FlexDraper FD2 has strips of uncut material because guards plugged with debris?
If you are experiencing strips of uncut material, try installing short knife guards to prevent guards from plugging with debris.
What to do if there is crop loss at cutterbar because of ground speed on MacDon New Holland FlexDraper FD2 Farm Equipment?
If you're experiencing crop loss at the cutterbar because the ground speed is too fast for the reel speed, increase the reel speed or reduce the ground speed.
What to do if there is crop loss at cutterbar because of cutterbar height on MacDon New Holland FlexDraper FD2?
If you're experiencing crop loss at the cutterbar and suspect it's because the cutterbar is too high, lower the cutterbar.
What to do if there is crop loss at cutterbar because of reel height on MacDon New Holland FlexDraper FD2 Farm Equipment?
If you're experiencing crop loss at the cutterbar and you think the reel is too high, lower the reel.
What to do if there is crop loss at cutterbar because of header angle on MacDon Farm Equipment?
If you're experiencing crop loss at the cutterbar due to a header angle that is too low, increase the header angle.
What to do if there is cut grain falling ahead of the cutterbar because of cutterbar height on MacDon Farm Equipment?
If cut grain is falling ahead of the cutterbar because the cutterbar is too high, lower the cutterbar.
What to do if there is cut grain falling ahead of the cutterbar because of reel height on MacDon New Holland FlexDraper FD2?
If cut grain is falling ahead of the cutterbar because the reel is too high, lower the reel.
What to do if there is cut grain falling ahead of the cutterbar because of ground speed on MacDon New Holland FlexDraper FD2?
If cut grain is falling ahead of the cutterbar because the ground speed is too slow, increase the ground speed.
General| Brand | MacDon |
|---|---|
| Model | New Holland FlexDraper FD2 Series |
| Category | Farm Equipment |
| Language | English |
To Next Page
