MacDon R116 User Manual (English)

Other manuals for MacDon R116

Operator's Manual294 pages

Quick Guide2 pages

Installation Instructions86 pages

Quick Card User Guide2 pages

Quick Start Guide2 pages

Assembly Instruction212 pages

Questions and Answers:

L
Lisa WilliamsJul 28, 2025
What to do if MacDon R116 cutterbar is plugging?
- T
  Tanner BennettJul 28, 2025
  If the cutterbar is plugging, several factors could be at play. It might be that the blades are dull, bent, or badly worn, in which case you should replace them. Another cause could be a build-up of dirt between the rock guards, so decreasing the mower conditioner angle and increasing flotation might help. In some cases, it may be necessary to carry the mower conditioner slightly with lower skid shoes. Finally, the conditioner drive belt might be slipping, requiring you to adjust the conditioner drive belt tension.
A
amandaperkinsAug 6, 2025
Why MacDon R116 leaves strips of uncut crop on the field?
- R
  Randy ScottAug 6, 2025
  Leaving strips of uncut crop on the field can happen for a few reasons. Check for bent or dull cutter blades and replace them if needed. A build-up of dirt between the rock guards can also cause this, so decrease the mower conditioner angle and increase flotation. Make sure your ground speed isn't too slow; if it is, increase it. Also, disengage the mower conditioner and stop the engine to remove any foreign object from the cutterbar.
J
John McdonaldAug 16, 2025
How to fix ragged or uneven cutting of crop with MacDon Farm Equipment?
- C
  Connor TrujilloAug 16, 2025
  Ragged or uneven cutting of crop could be due to several reasons. If the mower conditioner flotation is too light, causing bouncing, adjust to a heavier float setting. Excessive ground speed can also be a factor, so reduce ground speed. If you're dealing with downed crop, adjust the mower conditioner angle to cut closer to the ground.