To Next Page
S
Stacy RiceSep 8, 2025
What to do if there is insufficient roll gap in MacDon Farm Equipment?
- JJill MendozaSep 8, 2025
If there is insufficient roll gap, increase the roll gap.
What to do if there is insufficient roll gap in MacDon Farm Equipment?
If there is insufficient roll gap, increase the roll gap.
What to do if there is a foreign object between the rolls of MacDon Farm Equipment?
If you find a foreign object between the rolls, disengage the header and stop the engine. Make sure all moving parts have completely stopped before you attempt to remove the object.
What to do if there is mud on the MacDon Farm Equipment cutterbar?
If there is mud on the cutterbar, remove it immediately. Do NOT allow the mud to dry on the cutterbar.
What to do when cutting too low in rocky field conditions with MacDon Farm Equipment?
If you're cutting too low in rocky field conditions, decrease the header angle and increase the float.
What to do if the MacDon Farm Equipment roll timing is off?
If the roll timing is off, check the roll timing and adjust if necessary.
What to do if the MacDon Farm Equipment conditioner roll gap is too small?
If the conditioner roll gap is too small, check the gap and adjust if necessary.
What to do if the MacDon Farm Equipment roll gap is too large for proper feeding?
If the roll gap is too large for proper feeding, decrease the roll gap.
What to do if the MacDon Farm Equipment roll gap is too small in thick-stemmed cane-type crops?
If the roll gap is too small in thick-stemmed cane-type crops, increase the roll gap.
What to do if there is incorrect level of lubricant in the MacDon Farm Equipment cutterbar?
If there is an incorrect level of lubricant in the cutterbar (either too little or too much), drain the lubricant and refill with the specified amount.
What to do if the MacDon Farm Equipment discblades are dull, bent, or badly worn?
If the discblades are dull, bent, or badly worn, replace them.
General| Brand | MacDon |
|---|---|
| Model | R216 SP |
| Category | Farm Equipment |
| Language | English |
Explains the universal symbol indicating important safety messages.
Defines DANGER, WARNING, CAUTION, IMPORTANT, and NOTE signal words used in manual.
Lists the technical specifications and dimensions of the R216 SP Rotary Disc Header.
Instructions for the initial operation and break-in of the new header.
Daily checks to ensure the machine is ready for operation.
Procedures for safely engaging and disengaging header lift cylinder safety props.
Step-by-step guide for attaching the R216 SP header to the M1240 windrower.
Procedures for safely detaching the header from the windrower.
Details how to adjust header settings for optimal crop cutting performance.
Covers maintenance of the cutterbar discs, spindles, blades, accelerators, rock guards, and drums.
Lists common performance issues and their solutions for the header.
Addresses mechanical issues like noise, vibration, and component wear with solutions.
