214880 104 Revision A
Installing Suspended Drums
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove key, and
engage windrower lift cylinder safety props before going under machine for any reason.
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
NOTE:
Illustrations show right suspended drum, left suspended drum is opposite.
Figure 4.79: Driveshield
NOTE:
Ensure driveshield (B) is installed before suspended drum.
1. Position driveshield (B) as shown. Apply a bead of medium-
strength threadlocker (Loctite
®
243 or equivalent) around
the threads of two M10 hex flange head bolts (A). Use M10
hex flange head bolts (A) to secure driveshield (B) in place.
Figure 4.80: Suspended Drum
2. Position suspended drum (B) to shaft (C) as shown. Apply a
bead of medium-strength threadlocker (Loctite
®
243 or
equivalent) around the threads of four M12 hex flange
head bolts (A). Use the bolts to secure suspended drum to
shaft. Torque bolts to 100 Nm (74 lbf·ft).
MAINTENANCE AND SERVICING
To Next Page
Loading...
