214880 66 Revision A
4.3.2 Break-In Inspections
Table 4.1 Break-In Inspection Schedule
Inspection
Interval
Item
Refer to
1
Hour
Check for loose hardware and tighten
to required torque
7.1 Torque Specifications, page 161
5
Hours
Check for loose hardware and tighten
to required torque
7.1 Torque Specifications, page 161
5
Hours
Check conditioner drive belt drive
tension
Inspecting Conditioner Drive Belt, page 134
25
Hours
Check converging drum and feed
roller belt drive tension
Inspecting Conditioner Drive Belt, page 134
50
Hours
Check conditioner drive belt tension Inspecting Conditioner Drive Belt, page 134
50
Hours
Change conditioner roll timing
gearbox lubricant
4.6.1 Checking and Changing Conditioner Roll Timing Gearbox Oil,
page 124
50
Hours
Change header drive gearbox
lubricant
4.7.2 Changing Header Drive Gearbox Oil, page 129
4.3.3 Preseason Servicing
CAUTION
• Review the operator's manual to refresh your memory on safety and operating recommendations.
• Review all safety signs and other decals on the self-propelled disc header and note hazard areas.
• Ensure all shields and guards are properly installed and secured. Never alter or remove safety equipment.
• Make certain you understand and have practiced safe use of all controls. Know the capacity and the operating
characteristics of the machine.
• Check the first aid kit and fire extinguisher. Know where they are and how to use them.
Perform the following procedures at the beginning of each operating season:
1. Lubricate machine completely. Refer to 4.4 Lubrication, page 68 and 4.5.1 Lubricating Cutterbar, page 71.
2. Perform all annual maintenance. Refer to 4.3.1 Maintenance Schedule/Record, page 64.
MAINTENANCE AND SERVICING
To Next Page
Loading...
