MacDon R216 SP - Page 73

214880 65 Revision A
Every 25 Hours
2
ü
Check conditioner drive belt tension.
Refer to Inspecting Conditioner Drive Belt,
page 134 .
S
Lubricate idler pivot. Refer to 4.4
Lubrication, page 68.
S
Lubricate upper and lower driveline
universal joints. Refer to 4.4 Lubrication,
page 68 .
S
Lubricate roller conditioner and feed
roller bearings. Refer to 4.4 Lubrication,
page 68 .
S
Lubricate conditioner driveline .Refer to
4.4 Lubrication, page 68.
Every 100 Hours or Annually
ü
Check conditioner drive belt tension.
Refer to Inspecting Conditioner Drive Belt,
page 134 .
ü
Check roll timing gearbox lubricant. Refer
to 4.6.1 Checking and Changing
Conditioner Roll Timing Gearbox Oil, page
124.
ü
Check header drive gearbox lubricant.
Refer to 4.7.1 Checking Header Drive
Gearbox Oil, page 127
Every 250 Hours
3
▲
Change roll timing gearbox lubricant.
Refer to 4.6.1 Checking and Changing
Conditioner Roll Timing Gearbox Oil, page
124.
▲
Change header drive gearbox lubricant.
Refer to 4.7.2 Changing Header Drive
Gearbox Oil, page 129
▲
Change cutterbar lubricant. Refer to 4.5.1
Lubricating Cutterbar, page 71.
▲
Lubricate left and right driven drums.
Refer to Removing Left Driven Drum and
Driveline, page 105 and Removing Right
Driven Drum and Driveline, page 110
MAINTENANCE AND SERVICING
2. The driveline inside the driven drum is lubricated for life and does not require any routine lubrication.
3. Begins after the first 150 hour service.