214880 102 Revision A
Figure 4.74: R216 SP
9. Close cutterbar curtain (A). Refer to 3.7.2 Closing Cutterbar
Curtain, page 43.
Removing Suspended Drums
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove key, and
engage windrower lift cylinder safety props before going under machine for any reason.
WARNING
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear gloves when
handling blades.
NOTE:
Illustrations show right suspended drum, left suspended drum is opposite.
1. Raise the header.
2. Shut down the engine, and remove the key from the ignition.
3. Engage windrower lift cylinder safety props. Refer to 3.3.1 Engaging and Disengaging Header Safety Props – M1240
Windrower, page 22
Figure 4.75: Cutterbar Curtain
4. Open cutterbar curtain (A). Refer to 3.7.1 Opening
Cutterbar Curtain, page 42.
MAINTENANCE AND SERVICING
To Next Page
Loading...
