214880 48 Revision A
3.9.1 Changing R216 SP Cutterbar Crop Stream Configuration
Figure 3.58: R216 SP (10 Disc) Spindle Rotation Pattern and Crop Streams
A - Four Crop Stream B - Two Crop Streams
NOTE:
Refer to Removing Cutterbar Spindles, page 81 and Installing Cutterbar Spindles, page 83.
To change R216 SP (10 disc) spindle rotation from four crop streams (A) to two crop stream (B):
• Swap disc/spindle (3) with disc/spindle (8).
NOTE:
A disc timing tool (MD #307954) is available through MacDon parts to change disc/spindle configuration.
NOTE:
Switching from 4 streams to 2 streams is a recommended setting when cutting light alfalfa and using the double windrower
attachment (DWA).
OPERATION
To Next Page
Loading...
