To Next Page
L
Linda TylerAug 30, 2025
What to do if the MacDon Farm Equipment conditioner roll timing is off?
- Cchristian87Aug 30, 2025
If the conditioner roll timing is off, check the roll timing and adjust if necessary.
What to do if the MacDon Farm Equipment conditioner roll timing is off?
If the conditioner roll timing is off, check the roll timing and adjust if necessary.
What to do if there is insufficient roll gap in MacDon Farm Equipment?
If there is insufficient roll gap, increase the roll gap.
What to do if the MacDon Farm Equipment discblades are dull, bent, or badly worn?
If the discblades are dull, bent, or badly worn, replace them.
What to do if the MacDon Farm Equipment rolls are not crimping crop sufficiently?
If the rolls are not crimping the crop sufficiently, decrease the roll gap.
What to do if crop is bunched in the windrow of my MacDon Farm Equipment?
If the crop is bunched in the windrow, adjust the forming shields/baffle.
What to do if the MacDon Farm Equipment conditioner roll gap is too small?
If the conditioner roll gap is too small, check the gap and adjust if necessary.
What to do if my MacDon Farm Equipment has broken, bent, or dull blades?
If the blades are broken, bent, or dull, replace them or turn them over.
What to do if my MacDon Farm Equipment conditioner drive belt is slipping?
If the conditioner drive belt is slipping, adjust the conditioner drive belt tension.
What to do if the MacDon Farm Equipment disc is not turning?
If the disc is not turning, replace the spindle shear pin.
What to do if there is mud on the MacDon Farm Equipment cutterbar?
If there is mud on the cutterbar, remove it immediately. Do NOT allow the mud to dry on the cutterbar.
General| Brand | MacDon |
|---|---|
| Model | R216 SP |
| Category | Farm Equipment |
| Language | English |
Explains the universal symbol indicating important safety messages.
Defines DANGER, WARNING, CAUTION, IMPORTANT, and NOTE signal words used in manual.
Lists the technical specifications and dimensions of the R216 SP Rotary Disc Header.
Instructions for the initial operation and break-in of the new header.
Daily checks to ensure the machine is ready for operation.
Procedures for safely engaging and disengaging header lift cylinder safety props.
Step-by-step guide for attaching the R216 SP header to the M1240 windrower.
Procedures for safely detaching the header from the windrower.
Details how to adjust header settings for optimal crop cutting performance.
Covers maintenance of the cutterbar discs, spindles, blades, accelerators, rock guards, and drums.
Lists common performance issues and their solutions for the header.
Addresses mechanical issues like noise, vibration, and component wear with solutions.
