To Next Page
L
Linda TylerAug 30, 2025
What to do if the MacDon Farm Equipment conditioner roll timing is off?
- Cchristian87Aug 30, 2025
If the conditioner roll timing is off, check the roll timing and adjust if necessary.
What to do if the MacDon Farm Equipment conditioner roll timing is off?
If the conditioner roll timing is off, check the roll timing and adjust if necessary.
What to do if the MacDon Farm Equipment rolls are improperly timed?
If the rolls are improperly timed, adjust the roll timing.
How to fix build-up of dirt between rock guards on MacDon Farm Equipment?
To address dirt buildup between rock guards, decrease the header angle and increase float. In some conditions, it may be necessary to carry the header slightly with header lift cylinders.
What to do if the MacDon Farm Equipment header angle is too flat for guards to pick up downed crop?
If the header angle is too flat to pick up downed crop, increase the header angle.
What to do with downed crop using MacDon Farm Equipment?
To handle downed crop, adjust the header angle to cut closer to the ground.
What to do if the MacDon Farm Equipment header float is too light, causing bouncing?
If the header float is too light and causing bouncing, adjust to a heavier float setting.
What to do if the MacDon Farm Equipment roll gap is too large for proper feeding?
If the roll gap is too large for proper feeding, decrease the roll gap.
General| Brand | MacDon |
|---|---|
| Model | R216 SP |
| Category | Farm Equipment |
| Language | English |
Explains the universal symbol indicating important safety messages.
Defines DANGER, WARNING, CAUTION, IMPORTANT, and NOTE signal words used in manual.
Lists the technical specifications and dimensions of the R216 SP Rotary Disc Header.
Instructions for the initial operation and break-in of the new header.
Daily checks to ensure the machine is ready for operation.
Procedures for safely engaging and disengaging header lift cylinder safety props.
Step-by-step guide for attaching the R216 SP header to the M1240 windrower.
Procedures for safely detaching the header from the windrower.
Details how to adjust header settings for optimal crop cutting performance.
Covers maintenance of the cutterbar discs, spindles, blades, accelerators, rock guards, and drums.
Lists common performance issues and their solutions for the header.
Addresses mechanical issues like noise, vibration, and component wear with solutions.
