To Next Page
C
collinsaprilSep 2, 2025
What to do with downed crop using MacDon Farm Equipment?
- NNicholas AyalaSep 2, 2025
To handle downed crop, adjust the header angle to cut closer to the ground.
What to do with downed crop using MacDon Farm Equipment?
To handle downed crop, adjust the header angle to cut closer to the ground.
What to do if the MacDon Farm Equipment header float is too light, causing bouncing?
If the header float is too light and causing bouncing, adjust to a heavier float setting.
What to do if the MacDon Farm Equipment roll gap is too large for proper feeding?
If the roll gap is too large for proper feeding, decrease the roll gap.
What to do if the MacDon Farm Equipment roll gap is too small in thick-stemmed cane-type crops?
If the roll gap is too small in thick-stemmed cane-type crops, increase the roll gap.
What to do if the MacDon Farm Equipment swath baffle is set too low?
If the swath baffle is set too low, raise the swath baffle.
What to do if the MacDon Farm Equipment cutting height is too low?
If the cutting height is too low, decrease the header angle to raise the cutting height.
How to adjust the MacDon Farm Equipment swath baffle (deflector) if it is bypassing or dragging crop?
If the swath baffle (deflector) is bypassing or dragging crop, adjust the rear deflector for proper crop control.
How to adjust the forming shields on the MacDon Farm Equipment?
If the forming shields are improperly adjusted, adjust the roll conditioner forming shields.
What to do if the MacDon Farm Equipment cutting height is too high?
If the cutting height is too high, adjust the header angle steeper to lower the cutting height if field conditions allow.
What to do if crop gets into the MacDon Farm Equipment conditioner rolls before it is cut?
If crop gets into the conditioner rolls before it is cut, increase the roll gap.
Explains the universal symbol indicating important safety messages.
Defines DANGER, WARNING, CAUTION, IMPORTANT, and NOTE signal words used in manual.
Lists the technical specifications and dimensions of the R216 SP Rotary Disc Header.
Instructions for the initial operation and break-in of the new header.
Daily checks to ensure the machine is ready for operation.
Procedures for safely engaging and disengaging header lift cylinder safety props.
Step-by-step guide for attaching the R216 SP header to the M1240 windrower.
Procedures for safely detaching the header from the windrower.
Details how to adjust header settings for optimal crop cutting performance.
Covers maintenance of the cutterbar discs, spindles, blades, accelerators, rock guards, and drums.
Lists common performance issues and their solutions for the header.
Addresses mechanical issues like noise, vibration, and component wear with solutions.
General| Brand | MacDon |
|---|---|
| Model | R216 SP |
| Category | Farm Equipment |
| Language | English |
