Mackie THUMP212XT - Technical Specifications; Acoustic and Electrical Specs; Physical Properties and Mounting

Thump212XT and Thump215XT 1400W Enhanced Powered Loudspeaker Series
20
Thump212XT and Thump215XT 1400W Enhanced Powered Loudspeaker Series
ThumpXT Loudspeakers Specifications
Appendix B: Technical Information
Safety Features
Input Protection Peak and RMS limiting, power supply
and amplifier thermal protection
Display LEDs Voicing Mode, Outdoor Mode,
Music Ducking, Feedback Eliminator,
Front LED, Bluetooth Status,
Link Status, Overload
Physical Properties
Thump22XT:
Height: 24.4 in / 620 mm
Width: 4.0 in / 356 mm
Depth: 4.0 in / 356 mm
Weight: 27.6 lb / 2.5 kg
Thump25XT:
Height: 27.4 in / 696 mm
Width: 7.3 in / 439 mm
Depth: 4.0 in / 356 mm
Weight: 32.6 lb / 4.8 kg
Mounting Methods:
Floor mount, pole mount via the built-in socket on the bottom
of the cabinet [Be sure the pole is capable of supporting
the weight of the ThumpXT loudspeaker] or fly via the integrated
M0 mounting points (using M0 x .5 x 20 mm forged shoulder
eyebolts).
See pages 6–7 for more information.
Options
Thump22XT Speaker Bag P/N 2047360-09
Thump22XT Rolling Speaker Bag P/N 2047360-0
Thump25XT Speaker Bag P/N 2047360-
Thump25XT Rolling Speaker Bag P/N 2047360-2
T00 Loudspeaker Tripod Stand P/N 2052464
SPM400 Loudspeaker Pole Mount P/N 205055
PA-A Forged Shoulder Eyebolt Kit
(3 x M0 x .5 x 20 mm) P/N 003943
Disclaimer
Since we are always striving to make our products better
by incorporating new and improved materials, components,
and manufacturing methods, we reserve the right to change
these specifications at any time without notice.
The “Running Man” figure is a registered trademark of LOUD
Audio, LLC.
All other brand names mentioned are trademarks or registered
trademarks of their respective holders, and are hereby
acknowledged.
©2022 LOUD Audio, LLC. All Rights Reserved.
Acoustic Performance
Frequency Range (–0 dB) 47 Hz – 23 kHz [Thump22XT]
40 Hz – 23 kHz [Thump25XT]
Frequency Range (–3 dB) 54 Hz – 20 kHz [Thump22XT]
47 Hz – 20 kHz [Thump25XT]
Horizontal Coverage Angle 90º
Vertical Coverage Angle 60º
Maximum SPL Peak 28 dB [Thump22XT]
29 dB [Thump25XT]
Monitor Angle 40˚
Transducers
Low Frequency 2 in / 305 mm [Thump22XT]
5 in / 38 mm [Thump25XT]
with ferrite
High Frequency .0 in / 25 mm polymer
compression driver
Power Amplifiers
System Power Amplification
Rated Power 400 watts peak
Low Frequency Power Amplifier
Rated Power 200 watts peak
Rated THD < %
Cooling Convection
Design Class D
High Frequency Power Amplifier
Rated Power 200 watts peak
Rated THD < %
Cooling Convection
Design Class D
System Processing
Voicing Four speaker modes
Input/Output
Input Type 2x Female XLR – /4" Balanced
TRS combo jack and /8" TRS
Mic/Line Impedance 0 k
Balanced
/8˝ Line Impedance 0 k
Balanced
Thru Out Male XLR Balanced
Thru Out Impedance 300
Balanced
Electronic Crossover
Crossover Frequency 2. kHz
Line Input Power
Detachable line cord 00–240V~, 50–60 Hz, 75W
AC Connector 3-pin IEC 250 VAC, 0 A male
Power Supply Type Switchmode