Mackie THUMP212XT - Page 35

2/5 PAGES
THUMPXT 2022 SERIES SPECIFICATIONS
Acoustic Performance
Frequency Response (–0 dB) 47 Hz – 23 kHz [Thump22XT]
40 Hz – 23 kHz [Thump25XT]
Frequency Response (–3 dB) 54 Hz – 20 kHz [Thump22XT]
47 Hz – 20 kHz [Thump25XT]
Horizontal Coverage 90°
Vertical Coverage 60°
Maximum SPL Peak 28 dB [Thump22XT]
29 dB [Thump25XT]
Monitor Angle 40°
Transducers
Low Frequency 2 in / 305 mm [Thump22XT]
5 in / 38 mm [Thump25XT]
with ferrite
High Frequency .0 in / 25 mm polymer
compression driver
Power Amplifiers
System Power Amplification
Rated Power 400 watts peak
Low Frequency Power Amplifier
Rated Power 200 watts peak
Rated THD <%
Cooling Convection
Design Class D
High Frequency Power Amplifier
Rated Power 200 watts peak
Rated THD <%
Cooling Convection
Design Class D
System Processing
Voicing Four speaker modes
Input / Output
Input Type 2x Female XLR – /4" Balanced
TRS combo jack and /8" TRS
Mic/Line Impedance 0 kΩ Balanced
/8˝ Line Impedance 0 k Balanced
Thru Out Male XLR Balanced
Thru Out Impedance 300 Ω Balanced
Electronic Crossover
Crossover Frequency 2. kHz
Line Input Power
Detachable line cord 00–240V~, 50–60 Hz, 75W
AC Connector 3-pin IEC 250 VAC, 0 A male
Power Supply Type Switchmode
Safety Features
Input Protection Peak and RMS limiting, power supply
and amplifier thermal protection
Feedback Eliminator On / O
Display LEDs Voicing Mode, Outdoor Mode,
Music Ducking, Feedback Eliminator,
Front LED, Bluetooth Status,
Link Status, Overload
Mounting Methods:
Floor mount, pole mount via the built-in socket on the bottom
of the cabinet [Be sure the pole is capable of supporting
the weight of the ThumpXT loudspeaker] or fly via the integrated
M0 mounting points (using M0 x .5 x 20 mm forged shoulder
eyebolts).