2016
7
Main body
8
wiring
9
steel wire
10
power cable
11
Fan blades
Notice: keep the upper and under plane horizon-
tal, then tighten up the relevant bolts.
Notice: Don't cut the copper wire when stripping off, first connect ground wire
(yellow-green one or yellow one if no yellow-green), connect one-to-one according
to the color and then wrapped with wiring cap in case of exposing copper wire.
Notice: Four steel wires should be isometric, symmetrical, ensure all points bear stress
evenly, the steel wire clamps must be tightened up and glued, same with the
turnbuckles.
Notice: Wiring should be tight, firm and nice-looking.
Notice: Keep the blade surface good and install diagonally, two people work together
will be the best so that can ensure the tightening effect.
-11-
INSTALLATION GUIDE
To Next Page
Loading...
