Macrom M2A.2000 - Features; Technical Data

Features
RMS Power at 4 ohm Stereo load at 14,4 volts 60 x 2 watts
RMS Power at 2 ohm Stereo load at 14,4 volts 90 x 2 watts
RMS Power at 4 ohm Bridged load at 14,4 volts 180 x 1 watts
THD (total Harmonic Distortion) < 0,1%
Frequency response (+0/-1 dB) 10 - 30,000Hz
Signal to noise ratio > 95dB
Low Input sensitivity 200-8,000mV
High Input sensitivity 1-10V
Input impedance 22k /100 ohm
Crossover type Variable 18/12 dB/octave
Crossover frequency & filter slop (High-pass) 30 to 600Hz (x1) 300 to 6,000Hz (x10)
Crossover frequency & filter slop (Low-pass) 30 to 600Hz (x1) 300 to 6,000Hz (x10)
Dimension (w * h * d) mm 244 x 54 x 190
06
• Two channel power amplifier
• 90 x2 watts into 2 ohms load
• 60 x2 watts into 4 ohms load
• TO3P transistor on amplifier stage
• Variable Low-High-Band pass x-over at 18/12dB/oct
• Multiplier x1/x10 Frequency cutting
• Adjustable x-over from 30Hz to 600Hz (x1), 300Hz to 6000Hz (x10)
• Stereo/Mono mode selector (ST/mono Out)
• PWM Mos-Fet power supply
• High level Input (booster In)
• Mos-Fet power sup
Technical data