5
www.magellangps.com
Connecting to a Computer
The Magellan eXplorist 350H receiver can be connected to a
computer to perform firmware/map updates and, using the
VantagePoint software, provide additional trip planning tools.
Turn the Magellan eXplorist 350H receiver on and open the
USB cover as shown. When closing the cover be sure to close
it firmly to prevent water or dirt from entering the USB port.
Connect a mini-USB cable from the USB port on the receiver
to a USB port on your computer.
On the device select CONNECT TO PC. After a short period of time the device will display that it is
connected to the computer.
Updates
The Magellan eXplorist 350H receiver can be updated from the Magellan website or through the
Magellan VantagePoint software when updates are available.
Register Your Device: Go to www.magellangps.com to register your Magellan eXplorist 350H
receiver. If you do not have a Magellan account you will need to create one.
Updating via Web: Go to www.magellangps.com/support and select Manuals and Software
Downloads > Magellan Outdoor > eXplorist Series. Available updates can be found under eXplorist
350H. Download the updater and run it on your computer with the Magellan eXplorist 350H receiver
connected.
Updating via VantagePoint: Download and install VantagePoint software from www.magellangps.
com/Maps/VantagePoint_Software/VantagePoint. (Compatible with Windows
®
OS only.) Once
installed VantagePoint can be used to automatically check for updates and install them when
available.
To Next Page
Loading...
Need help?
General