MAINTENAN( :E 11
Depending on your model, your RV range or cooktop will Do not place excessive weight on an open oven door or
featurethreeorfoursurfaceburners. Eachburnerissecured stand on an open oven door as, in some cases, it could
inplacewith ascrew.When burneriscool, removethe screw cause the rangeto tip over, breakthe door,or cause senous
beforeremoving the burner. When re-installing the surface injury to the user.
burner be sure to replace the screw.
When opening the oven door, allow steam and hot air to
Ifthesufface burnerdoesnotlight, checktoseeiftheburner escape before reaching in oven to check, add or remove
ports are clogged. If so, clean with a straight pin or small food.
metalpaper clip.Be sure the standing pilot is lit. Checkto be
surethat the burner is correctly installed.
Toinstallsurface burner:The airshutterend onthe burner YourRVrangefeaturesone oven rackwithachoiceoftwoor
shouldfitoverthe orificehood. threerackpositions.The ovenrackisdesignedwithasafety
lock-stoppositiontokeep the rackfromaccidentlycoming
_tt completelyout ofthe ovenwhen pullingthe rackout toaddor
remove food. The rack also features two tabs to keep the
\_\. rack from rattlingduring travel.
"\\
er
To install surface burner with Piezo ignition: The two
tabson eachflashtubeshouldbe securelyinsertedintothe
two slotsoneach burnerhead,
Slo_ _ I CAUTION: DOnot attempt to change the rackposition
....._"_i__'_ t when the oven is hot.
) _, ,, Two To remove: Be sure rack is cool. Pull the rack straight out
Tabs until it stops. This releases the two tabs on the sides of the
rack. Tilt the front end of the rack up, then push the rackto
the back of the oven. Liftthe rearof the rack up,then remove
it from the oven.
The flashtube "holddown"clips shouldsecure the flashtube
inplace. The clips are located under the metal shield. To replace: Place the oven rackin the oven, on _ of the
racksupports.Pushtheracktothe backofthe oventoallow
Flash _Flash..._ the rackto drop intoplace. Pullthe rackforward to the stop
e_ _.u_b position.Then,asyoupushthe rackback, lowerthetwo tabs
(_ under the rack support.Th!s will anchorthe rack intoplace
_"Hold down" and prevent it from rattling during travel.
Hold down"
To Next Page
Loading...
Need help?
General
