www.magicard.com
RIO 2e, TANGO 2e & TANGO +L Printers USER MANUAL
Page 7 of 33
Installing to USB continued -
Wait while the USB driver files are installed and registered
6. At the “Installation Successful” window – click ‘F
inish’.
7. Make sure the printer is connected via the USB cable to
your PC. Then switch ON the printer.
There will be a short delay while the printer initializes.
Then Windows will detect the printer via the USB
connection and will complete the installation.
8. It is recommended that you test the new driver installation by printing a Windows Test Page from the ‘General’ tab
of the Printer Driver Properties – the Windows Logo should be printed in the centre of the card.
(To configure the new Printer Driver’s settings please see Section 11 – Printer Driver Settings – for a detailed explanation of
each setting).
CAUTION:-
If the computer you are configuring for a USB connection to the Magicard printer has at some time run
another manufacturer’s printer (e.g. Eltron C-Series printer), a Windows file necessary for the Magicard
installation could be missing.
(The symptoms of this are that the computer does not seem to detect the printer’s USB connection, and
the Test Page fails to print).
Recover the file as follows:-
1. Navigate to c:\windows\inf (Windows XP) or c:\winnt\inf (Windows 2000).
2. Find the file named usbprint.in, and then rename it to usbprint.inf.
3. Reconnect the USB cable.
To Next Page
Loading...
