3138 155 23293
1
TV CHANNEL INSTALLATION
A U T O S T O R E
P L E A S E W A I T
P R O G . F O U N D 0
C H A N N E L 3
C C
SO UR CE
P I P
M E N U
O K
I N S T ALL
L A N G UAGE
T U N E R MODE
A U T O PROGRAM
C H A N NEL EDIT
F A C T ORY RESET
cable
I N S T A L L
L A N G U A G E
T U N E R M O D E
A U T O P R O G R A M
C H A N N E L E D I T
F A C T O R Y R E S E T
S T A R T ?
M A N U A L F I N E T U N E
M A N U A L F I N E T U N E
M A IN CONTROLS
P I CTURE
A U DIO
F E ATURES
I N STALL
L A NGUAGE
T U NER MODE
A U TO PROGRAM
C H ANNEL EDIT
F A CTORY RESET
M A NUAL FINE TUNE
Please follow these steps to install TV channels:
Select a TV channel via SOURCE button on your remote control.
Press MENU button on your remote control to open the onscreen menu.
Press CH(-) to move to INSTALL,press VOL(+) on your remote control to enter
INSTALL.
Press CH(-) to select TUNER MODE, press VOL(+) on your remote control to
select CABLE, ANTENNA or AUTO mode.
CABLE IF you have a cable input
ANTENNA IF you have an antenna input
AUTO IF you are not sure what kind of TV signal input you have
(Cable or Antenna)
Press CH(-) to move to AUTO PROGRAM.
Press VOL(+) to start auto install the TV Channels.
1
2
3
4
For more detailed explanation of AUTO PROGRAM, please refer to
AUTO PROGRAM section on page 5.
5
Immediately after unpacking and plugging in your new television, run the auto program function
to set up the TV for the broadcast or cable channels available in your area. If you do not run the
auto program function to set up the channels , your television may not operate properly.
Expanding the base requires a degree of force; please use sufficient force to unfold the base.
When unfolding the base, place the TV on a flat, sturdy surface before expanding the base.
6
UNFOLD THE BASE
To Next Page
Need help?
Picture/Display
Power
