–
11
–
EN
CONNECTING TO EXTERNAL INPUT JACKS
When you watch a program recorded on another
source (VCR or video camera), use the audio/video
input jacks on the front of the unit.
Connect the audio/video output
jacks of another source to the
AUDIO L/R and VIDEO jacks of
this unit.
Then hit [SELECT] until
"AUX" appears on the screen.
NOTE:
•
When you connect a monaural VCR (another
source) to this unit, connect the Audio output jack
of the monaural VCR (another source) to the
AUDIO L jack of this unit. The audio will output in
both L and R channel equally.
STANDBY-ON
VIDEO
L
–
AUDIO
–
R
VIDEO
L
–
AUDIO
–
R
[Another source]
To the
audio out-
put jacks
Audio/Video
cables
(not supplied)
etc.
To the video
output jack
[Front of the unit]
AUX
[Fig. 5]
CONNECTING TO AN AMPLIFIER EQUIPPED WITH DIGITAL
INPUT JACKS, MD DECK OR DAT DECK (for DVD only)
Use an audio coaxial digital cable (commercially available) for the audio connections.
NOTES:
•
The audio source on a disc in a 5.1 channel Dolby Digital surround format cannot be recorded as digital
sound by an MD or DAT deck.
•
Be sure to turn off the power to all components in the system before connecting another component.
•
Refer to the Owner's Manuals for the components to be connected to the unit.
•
Set DOLBY DIGITAL to OFF for audio output in the setup mode. Playing a unit using incorrect settings
may generate noise distortion and may also damage the speakers. (See page 28 to set DOLBY DIGITAL to
OFF.)
To Next Page
Loading...
