SLEEP 0 MINUTE
C C C C C C C C C C C C
BRIGHT
–
PP PP PP PP PP PP PP CC PP PP PP PP PP PP PP
+
SLEEP TIMER SETTING
The Sleep Timer function is used to turn off the
unit without pressing
[STANDBY-ON y] after a
desired time.
1 Press [PICTURE / SLEEP] to
display the Sleep Timer menu.
2 Within 10 seconds, set your desired sleep time
using
[s / B].
• [B]...Increase by 10 min. (Up to 120 min.)
•
[s]...Decrease by 10 min.
NOTE:
•To cancel the Sleep Timer, use [CLEAR] or [s / B]
to set the time to "0".
3 To confirm the remainder time to shutdown,
press
[PICTURE / SLEEP].
PICTURE CONTROL
The picture controls are preset to factory defaults,
but you can change them to your desired setting.
1 Press [PICTURE / SLEEP]
repeatedly until desired control
is displayed.
2 Use [s / B] to adjust to your desired level within
5 seconds.
• Even if any power failure occurs, the unit will
retain its memory for this feature.
- TV SETUP -
CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
B CAPTION [CAPTION1]
- TV SETUP -
CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
B CAPTION [OFF]
CLOSED CAPTION SYSTEM
You can view specially labeled (cc) TV pro-
grams, movies, news and pre-recorded tapes with
either a dialogue caption or text display.
1 Press [SET-UP].
Use
[
KK
/
LL
] to point to
"CAPTION".
2 Press [ENTER] repeatedly to
select your desired caption
mode.
•
CAPTION mode: You can watch dramas, movies and
news while captioning the dialogues and the contents
of news.
• TEXT mode: You can watch half screen text informa-
tion if you want.
*"CAPTION2" is usually used for a second language (if
available).
3
Press [SET-UP] to exit the menu.
NOTES:
•Even if any power failure, the unit will retain its mem-
ory for this feature.
• Some programs are not broadcasted with closed
captions. The unit is designed to provide error-free
closed captions with high quality antenna, cable and
VCR signals. Conversely, poor quality signals are
likely to result in caption errors or no captions at all.
• Common signal conditions which may cause caption
errors are listed below:
- Weak snowy reception on TV screen
- Multiplex signal reception displaying picture
ghosts or airplane flutter
• If the unit displays a black box on
the TV screen, this means that
the unit is set to the TEXT mode.
To clear screen, select "CAP-
TION1", "CAPTION2" or "OFF".
TO CANCEL THE CLOSED CAPTION SYSTEM
1 Press [SET-UP]. Use [
KK
/
LL
] to point to
"CAPTION".
2 Press [ENTER] repeatedly to select "OFF".
3 Press [SET-UP] to exit the menu.
10
EN
TV SECTION
TV OPERATION AND SETTINGS