MAX Write: #MAX 2 Show Max/Min
#MAX 1 Show Max
#MAX 0 off
Answer: MAX 0, MAX 1 or MAX 2
Read: ?MAX
Answer: MAX 0, MAX 1 or MAX 2
MMAX Read only: ?MMAX Read the Max value
Answer: digits and unit, e.g.. 123 mT
MMIN Read only: ?MMIN Read the Min value
Answer: digits and unit, e.g.. -123 mT
RESET Write only: #RESET Max./Min. or Peak are set to Zero
Answer : OK
LOCAL Write: #LOCAL Go to local mode
Answer: OK
Read: ?LOCAL
Answer: LOCAL 0 Remote mode
LOCAL 1 Local mode
MEAS Read only: ?MEAS Read a single value
Answer: digits and unit, e.g. 123 mT
NMEAS Write: #NMEAS n n > 0: Presets a number of values to be sent;.
the measurement is started by MULTI 1
#NMEAS 0 Permanent sending of values until
MULTI 0 is received
Read: ?NMEAS
Answer: number of values
MULTI Write: #MULTI 1 Starts automatic data sending
#MULTI 0 Stops automatic data sending
Read: ?MULTI
Answer: MULTI 0 (off) or MULTI 1 (on)
CFIELD Write: #CFIELD 1 enable linearity correction
#CFIELD 0 disable linearity correction
Answer: CFIELD 0 or CFIELD 1
Read: ?CFIELD
Answer: CFIELD 0 or CFIELD 1
To Next Page
