8.2.1 User’s vehicles
Specify refrigerant weight □
Refrig. g. ■
Use UP-DOWN buttons to select the user’s vehicle. Confirm by pressing ENTER.
> User’s vehicle 1 <
User’s vehicle 2
Use UP-DOWN buttons to select the user’s vehicle. Confirm by pressing ENTER.
If settings for the vehicle were previously input, the following screen will appear:
Refrigerant qty g: XXXXX
Vacuum: XX:XX
Use UP-DOWN buttons to select programming of oil-UV injection phase. See 9.5
Programming oil-UV injection phase.
To change previously entered data, press and hold ENTER button for 3 seconds while
previous overhaul parameters are displayed.
To add a new user vehicle, select one of the empty slots in the model list and confirm by
pressing ENTER. The display will show:
User vehicles
User vehicle 1
Press and hold ENTER for 3 seconds, the display will show:
Refrigerant qty g: 700
Vacuum: 20
Press and hold ENTER for 3 seconds, the display will show:
User vehicle:
Enter user model name using UP and DOWN buttons.
See Błąd! Nie można odnaleźć źródła odwołania.. Editing
Confirm the model by pressing and holding ENTER for 3 seconds.
The display will show:
Name
Refrigerant qty g: 700
Enter the correct value using UP-DOWN buttons. Confirm by pressing ENTER.
To Next Page
Loading...