What to do if there is no change in output between wet gap or dry gap in Magnetrol Echotel 961?
If you observe no change in output between a wet gap and a dry gap on your Magnetrol Switch, check first to see if the transducer gap is plugged with solids. Also check for dense foam in the gap.
How to troubleshoot one flash of the Fault LED on Magnetrol Echotel 961 Switch?
If the Fault LED on your Magnetrol Switch flashes once, it indicates a problem with the transducer, piezoelectric crystals, or the interconnection wiring. Check all wiring inside the housing to ensure all wires are secure in their respective terminal blocks and that all terminal block screws are fully tightened. If all wires are secure, a replacement transducer may be needed, so contact the factory.
What to do if the LED flashes twice on my Magnetrol Switch?
If the LED on your Magnetrol Switch flashes twice, it indicates an issue with the electronics module. Contact the factory for a replacement electronics module.
Steps to reduce component failure risk from static electricity during installation.
Guidance on mounting positions for Model 961 and 962, emphasizing proper transducer orientation.
Details wiring for the remote transducer of the Model 961 loop-powered unit.
Details wiring for the remote transducer of the Model 962 loop-powered unit.
Explains the 25-turn potentiometer for adjusting signal averaging time.
Details Level Test and Malfunction Test push buttons for relay testing.
To Next Page
General
