10-10
© Copyright Mahindra & Mahindra Ltd.012016
3. Set the air distribution control to defrost mode
4. Select the fresh (outside) air intake mode
5. Adjust the temperature control knob to maintain comfort
To defrost/deice the outside windshield, follow the above steps
but switch OFF the AC. We recommend that the temperature
control should be on maximum heating
On humid days, do not blow cold air on the windshield and side
window glass, the difference between the outside and inside
cabin temperature could make the fogging worse.
10.12.2 Rear Windshield Demist (if equipped)
The rear windshield glass de — mist button is located in the AC
control panel; as shown in the sketch. Press the button once to
activate the demister. The LED on the button illuminates upon
activation and the demister heats the rear windshield clearing the
fog. Switch OFF the demister by pressing the button again as soon
as the fog is cleared.
The rear windshield de — mister switches OFF automatically
after a pre-defined time 10 minutes
10.12.3 HVAC Points to Remember
• For quickly clearing the misted/fogged/frosted-up windshield,
set the blower speed to maximum. For quick defrosting, set the
temperature to extreme hot
• Once the windshield is cleared, keeping the air conditioner ON
helps in keeping windshields and windows clear. Keep the fresh
air mode selected. If required, re-adjust the blower speed and
temperature control knob to maintain comfort.
• Driving the vehicle for long with glasses rolled up the air
conditioner switched OFF may lead to windshield or windows
getting misted/fogged up
• Driving the vehicle for long continuously in the recirculation mode
may lead to windshield or windows getting misted/fogged up
• It is advisable to intermittently switch to FRESH air mode during
long drives. Do not drive only in RECIRULATION mode
continuously on long drives
HEATING, VENTILATION AND AIR-CONDITIONING SYSTEM (HVAC)
To Next Page
Loading...
Need help?
General
