11-4
© Copyright Mahindra & Mahindra Ltd.012016
1. Shift the gear shift lever to neutral position.
When the vehicle is on gear, 90% of the clutch to be
pressed for starting the engine.
2. Apply parking brake.
3. Turn the ignition ON.
4. Do not press the accelerator.
5. Turn the key momentarily to the START position to crank the
engine
6. Once the engine starts, release the key; it will return to the IGN
position
Do not continue cranking after the engine has started.
This will lead to damage of the starter and other engine
components.
7. If the engine fails to start, attempt to restart after about 10
seconds
8. If the engine fails to start even after repeated attempts as per
the procedure given above, contact the nearest Authorized
Mahindra Dealer
To prevent damage to the starter, wait 10 seconds before
attempting to restart the engine.
If the vehicle battery has discharged, use booster cables, a
booster battery or a battery from another vehicle to start.
Jump-starting a vehicle can be dangerous if done improperly.
Refer to the “Jump-starting procedure” section in this manual.
If the engine still fails to start, contact an Authorized Mahindra
Dealer for assistance.
The idle speed is controlled automatically and it will decrease as the
engine warms up.
Observe the following when the engine is running;
• All warning lamps are OFF
• Low oil pressure lamp is OFF
After idling for a few seconds, release the parking brake, depress
the clutch, shift the gear shift lever to 1st gear, release the service
brake pedal, drive by releasing the clutch and depressing the
accelerator pedal simultaneously.
STARTING AND DRIVING THE VEHICLE
To Next Page
Loading...
Need help?
General
