© Copyright Mahindra & Mahindra Ltd. 012016
12-7
12.5.2 Wheel Tightness
When you change a wheel, remove all rust and dirt at all locations
where the wheel contacts the wheel hub. Use a scraper or wire
brush to be sure that you remove all rust and dirt. A loose wheel
could have damaged or elongated the holes in the rim, or damaged
the rim/hub assembly. If any of the wheel studs or nuts are
damaged, contact the nearest Authorized Mahindra Dealer.
Always tighten the bolts in a crisscross sequence. Never use oil
or grease on your wheel bolts.
Never over tighten the bolts on the wheel Hub. You could
damage the bolt or the hub.
Torque tighten the wheel bolts to the specified value at the
nearest Authorized Mahindra Workshop.
The tyres fitted in this vehicle meet the requirements of BIS and
they comply with the requirements under the Central Motor
Vehicles Rules (CMVR) 1989.
WHEELS AND TYRES
To Next Page
Loading...
Need help?
General
