Repair Manual MAN-
00190
THAR CRDe BS-IV MAY 2012/Rev
1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by
the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
• Remove Clutch release bearing and fork*.
*if applicable.
NOTE:
Ignore this step, if vehicle is fitted with Concentric
Slave Cylinder.
• If vehicle is fitted with Concentric Slave
Cylinder - Remove the Clutch fluid line from
the quick fix joint. Refer illustration.
NOTE:
Put a tray below clutch housing to avoid clutch
fluid seepage. Avoid dropping of fluid particles
over vehicle components.
Remove clutch housing from transmission
assembly. 09 nos. mounting bolts.
NOTE:
• Use mallet for slight tapping on bell housing
while removing from transmission.
To Next Page
Loading...
