Repair Manual MAN-00190
THAR CRDe BS-IV MAY 2012/Rev 1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
In Car Repairs -
• Transmission Removal –
• Before separating the transmission from the engine, remove the crankshaft position sensor
*(OBD) from the clutch housing. *(if applicable)
• Support transmission while removing it from vehicle.
• Remove battery –ve terminal.
• To prevent oil spills, drain Transmission and Transfer Case oil before removing transmission.
• Ensure and take care of rear oil seal while removing propeller shaft.
• Lift vehicle on four post lift.
• Remove battery terminals.
• Remove Clutch Slave Cylinder* from clutch
housing.
* Ignore this illustration and follow the next one
in case vehicle is fitted with Concentric Slave
Cylinder.
Cross Member below
transmission
To Next Page
Loading...
