Repair Manual MAN-00190
THAR CRDe BS-IV MAY 2012/Rev 1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra
& Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
3. Install the input shaft (A) into the front casing.
Check the oil seal prior to installation. In case of
replace the oil seal.
4. Using a MST, install an oil seal (A) into the
carrier assembly body.
5. Using a Circlip pliers (A), expand the snap ring
damages are observed, then replace the affected
component. Always ensure correct installation of
the bearing and the oil seal.
To Next Page
Loading...
