Repair Manual MAN-00190
THAR CRDe BS-IV MAY 2012/Rev 1
The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of Mahindra
& Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
groove in the outer clutch housing. The cage may
be easier to install if the tangs on the each side of
the cutout are installed first.
4. Install the steel inner cage inside the plastic
outer cage. (For clarity, the cages on the right are
shown outside the hub.) The window (A) must
engage the tang (B) of the outer cage for correct
positioning.
5. Install the large snap ring in the top groove of
the outer clutch housing.
6. Install the drag sleeve assembly in the inner
cage, so that the tangs of the brake band are
located on each side of the outer cage tang (C) and
in the window of the inner cage. Tilt the drag
sleeve slightly to engage the tangs, but be careful
not to cock the hub sleeve.
To Next Page
Loading...
