The repair methods given by the manufacturer in this document are based on the technical specifications, current at the time of release. The methods may be modified as a result of changes introduced by
the manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part of or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2021 Mahindra & Mahindra Ltd.
71
13.14.2 DIAGNOSTIC PROCEDURE
STEP 1 – PERFORM UICU PROGRAMMING
PRE CONDITION
• Turn ON ignition
TEST PROCEDURE
• Connect i-SECURE dealer tool and perform UICU assignment
Always use i-SECURE + V4.0.7 and above for any security components ECU
programming in “XUV 7OO”
ACCEPTANCE CRITERIA
• UICU assignment TPK should be generated
ACTION TO BE TAKEN
OK NOT OK
• Share the UICU assignment TPK to TEKliner or use
automated blue signature to generate ASC
• Turn OFF ignition for 2 minutes
• After 2 minutes turn ignition ON and make sure
previously set check lamps are cleared
• And crank the engine to start the vehicle
• Contact TEKliner for further
assistance
Diagnostic Manual
XUV700 (Diesel)
UICU
MAN-01065
OCT - 2021/Rev 1
To Next Page
Loading...
