Mahr Digimar M 814 G User Manual

Mahr GmbH , Digimar M 814
1
Contents
Safety instructions
I.1 Instrument construction -------------------------------------------------------------------------------------------------- 3
II.1 Function of the display --------------------------------------------------------------------------------------------------- 4
III.1 Specification ---------------------------------------------------------------------------------------------------------------- 5
IV.1 Delivery ----------------------------------------------------------------------------------------------------------------------- 6
V.1 Setting up -------------------------------------------------------------------------------------------------------------------- 6
VI.1 Measuring -------------------------------------------------------------------------------------------------------------------- 7
VI.1.1 Setting the measurement direction and the required resolution ------------------------------------------------- 7
VI.1.2 Measuring using rigid probes-------------------------------------------------------------------------------------------- 8
VI.1.3 Measuring of flat surfaces ----------------------------------------------------------------------------------------------- 8
VI.1.4 Measuring of flat surfaces using two references (REF I and REF II) ----------------------------------------- 8
VI.1.5 Measuring using one reference and PRESET input -------------------------------------------------------------- 10
VI.1.6 Measuring using MIN (Minimum) mode ------------------------------------------------------------------------------ 11
VI.1.7 Measuring using MAX (Maximum) mode---------------------------------------------------------------------------- 11
VI.1.8 Measuring using MIN-/MAX (Minimum-Maximum/Delta) mode ------------------------------------------------ 12
VI.1.9 Measuring using (TOL input) moe------------------------------------------------------------------------------------- 13
VI.1.10 MM/INCH conversion (direct conversion) --------------------------------------------------------------------------- 14
VI.1.11 ON/OFF (power connection/disconnection) ------------------------------------------------------------------------- 14
VII.1 Measuring with special accessories ---------------------------------------------------------------------------------- 15
VII.1.1 Measuring using bi directional probe 814 u ------------------------------------------------------------------------- 15
VII.1.2 Calibration of the bi directional probe 814 u ------------------------------------------------------------------------ 15
VII.1.3 Measuring centerline distances using centering cones ---------------------------------------------------------- 16
VII.1.4 Checking the parallelism ------------------------------------------------------------------------------------------------ 16
VII.1.5 Scribing using the scriber 814 a --------------------------------------------------------------------------------------- 16
VIII. Accessories ---------------------------------------------------------------------------------------------------------------- 17
IX.1 Maintenance --------------------------------------------------------------------------------------------------------------- 18
IX.1.1 Maintenance --------------------------------------------------------------------------------------------------------------- 18
IX.1.2 Replacement of the battery--------------------------------------------------------------------------------------------- 18
IX.1.3 Transport -------------------------------------------------------------------------------------------------------------------- 18
IX.1.4 Repairs ---------------------------------------------------------------------------------------------------------------------- 18
IX.1.5 Complaints ----------------------------------------------------------------------------------------------------------------- 18

Mahr Digimar M 814 G Specifications

General

Brand	Mahr
Model	Digimar M 814 G
Category	Measuring Instruments
Language	English