Need help?Do you have a question about the Mahr Digimar 817 CLM and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Repeatability | 0.001 mm |
| Measuring speed | Max. 1.5 m/s |
| Protection class | IP40 |
| Accuracy | ± 0.002 mm |
| Power Supply | Battery |
| Operating temperature | 0°C to 40°C |
| Data interface | RS-232 |
| Storage Temperature | -10 to +60 °C |
| Resolution | 0.001 mm |
Detailed explanation of the various parts of the height measuring instrument with numbered labels.
Explanation of the different key groups and their functions on the instrument's keypad.
Describes the various elements displayed on the instrument's screen and their meanings.
Guide to configuring essential initial settings like language, units, and resolution.
Procedure for establishing the instrument's zero point on the base plate.
Step-by-step guide on how to calibrate the measuring probe for accurate readings.
Step-by-step instructions for measuring the diameter and center of a bore.
Step-by-step instructions for measuring the diameter and center of a shaft.
Detailed procedure for standard calibration of the measuring probe.
Step-by-step instructions for calibrating the probe with a setting standard.
Procedure to calibrate a twin probe and its associated functions.
Detailed steps for calibrating a probe against a ledge.
Instructions for setting the basic zero point on the instrument's base plate.
Procedure to set the first workpiece zero point (01).
Procedure to set the second workpiece zero point (02).
Procedure to set the third workpiece zero point (03).
Guide to entering a preset value, which acts as an offset zero point.
How to use the MAX-MIN function to find extreme values during measurement.
Procedure for entering a tilting angle for arithmetic workpiece alignment in 2D mode.
Procedure for calculating index circles or best fit circles using multiple points.
How to align the workpiece arithmetically in 2D mode using coordinate transformation.
Instructions for deleting measured values, either the last or all.
Steps to connect and save measured data to a PC via USB.
Setting up temperature compensation for accurate measurements.
How to delete all data from the instrument's memory.
How to calibrate correction factors for the Z-axis, including data deletion.
Common problems, their reasons, and solutions for the instrument.
To Next Page
