Mahr Digimar 817 CLM - Manually Entering Tilting Angle

58
Mahr GmbH • Digimar 817 CLM
– Determine the distance and angle of 2 elements
– Determine the distance and angle of 3 elements
– Index circle / best fit circle
– Coordinate transformation– aligning the test piece arithmetically
– Deactivate the 2D mode
– Tilt the workpiece
4.5.1 Manually enter a tilting angle
– Active the 2D key
Select:
- Manually enter the tilting angle
- Calculate tilting angle
- Active 2D
- Tilt workpiece
– Manually enter the tilting angle (standard is 90°)
If the tilting angle is < or > than 90° then the „X-correction“ will appear
in the 2D mode.
Description / Sequence Symbols / Pictures
z
x
2D
OFF
2D
a
a
z
x
2D
ON
2D
OFF
a
a