71
Mahr GmbH • Digimar 817 CLM
4.7 Measuring with a taper probe
Area of application:
For rapid determination of coordinates on workpieces with a rough
tolerances (e.g. master gage for holes, perforated plate, threads. . .
+/- 0.2 mm
Procedure:
– Measure a bore with a taper probe.
Requirement: the taper probe is calibrated. The bore must be
smaller the diameter of the taper <30.00 mm
– Note the measured center of the bore e.g. 207.516 mm
Description / Sequence Symbols / Pictures
– Loosen the knurled screw and remove the standard probe,
replace this with a taper probe and
tighten up the knurled screw.
– Calibrate the probe
– Select taper probe
– Enter the diemater of the taper
– Confirm by pressing the the taper symbol
To Next Page
Loading...
