Mahr Digimar 817 CLM - Measuring a Bore with Speed Keys

35
Mahr GmbH • Digimar 817 CLM
Description / Sequence Symbols / Pictures
3.3.4 Measuring a bore
Note: „Measuring a bore“ must be active.
See chapter 3.3.3
– Position the probe into the bore, the probe must be off-set
– To start measurement, briefly press the speed key.
<0.5 s
contact
from below
(upwards)
<0.5 s
contact
from above
(downwards)
3.4 Abort a measurement:
Should a measurement have been inadvertently started, simply press a
speed key or the cancel key, this is sufficient to abort the measurement.