4.8.6 Relative zero point
– Contact the plane F4 from above
Description / Sequence Symbols / Pictures
0,00
See Workpiece-zero point 01
– Press the function key „Set zero point“, the last measured
characteristic will appear in the display as Workpiece-zero
point 01.
In this example: Dimension = 60.001
⇒ Value 0.000 will be displayed
– Contact the plane F4 from above. Plane F4 is set to „Zero“.
⇒ Result 60.001 will be displayed
All further characteristics refer to plane F4 until a further
workpiece zero point is set, or zero point 01 is deleted.
To Next Page
Loading...
