82
Mahr GmbH • Digimar 817 CLM
5.3 Print measured values / results
5.3.1 Settings
In „menu“ the following settings can be implemented:
The operator can chose to transfer the data and / or
the measured values between:
Manual Data transmission, once the „DATA key“
has been pressed
Automatic Automatic data transmission after each
value has been measured
1. <-_______
2. Standstill-time
3. Contacting speed
4. Resolution
5. mm/inch
6. Language
7. Date and time
8. LCD settings
9. Beep ON/OFF
10. Auto – off time (min)
11. Quick-Mode
12. Perpendicularity
13. Data and printer
14. Advanced settings
1. <-_______
2. DATA auto-transmit on/off
3. USB printer menu
4. Interface parameters RS 232 Out
5. Transmission content RS 232 Out
6. USB file system management
1. Send using DATA key
2. Send automatically
1. <-_______
2. Standstill-time
3. Contacting speed
4. Resolution
5. mm/inch
6. Language
7. Date and time
8. LCD settings
9. Beep ON/OFF
10. Auto – off time (min)
11. Quick-Mode
12. Perpendicularity
13. Data and printer
14. Advanced settings
1. <-_______
2. DATA auto-transmit on/off
3. USB printer menu
4. Interface parameters RS 232 Out
5. Transmission content RS 232 Out
6. USB file system management
1. <-_______
2. Printout results
3. Change record head data
4. Change record head form
5. Printer page length
6. Change customer-specific headline
7. Color printer Yes/No
8. Printer specification
1. Yes
2. No
3. Print part memory
1. Yes = The measured values will either be prepared
for print manually via the DATA key or automatically,
i.e. when a page is full with measured values, the
print will be started. By using the paper feed, values
can be individually be printed.
2. No = Measured values will not be printed.
3. Workpiece memory = will be printed immediately.
To Next Page
Loading...
Need help?
General
