Mahr Digimar 817 CLM - Entering Tilting Angle for Arithmetic Alignment

59
Mahr GmbH • Digimar 817 CLM
4.5.2 Entering a tilting angle
(arithmetic workpiece alignment)
Mount both the probe and holder, see chapter 4.4.2
– Press the 2D key
Select:
- Manually enter the tilting angle
- Calculate tilting angle
- Active 2D
- Tilt workpiece
– Measure the tilting angle
The following menu appears in the determination of the
perpendicularity error
– See chapter 4.4.2
Measuring the perpendicularity error
The following menu will appear:
– Accept the angle
– Stop measurement and go to the graphic mode
– Accept the tilting angle α
– Abort
Accept the tilting angle α:
Calculating the tilted angle can be used for further 2D measurements.
Description / Sequence Symbols / Pictures
2D
a
a
z
x
2D
ON
a
a
a